Display Config-Manual

Function Introduction: Move the display area so that the arc position is in the center.

Setting Step（Move the display area）：

(1 )Enter "System Debug" Menu.

(2) Select the" Display Config-Manual " and press " Menu " to enter the page.

(3 )The screen will show “Place Fiber，Press ’Enter‘”.

(4) After inserting the fiber optic cable, press “Menu ” to continue.

(5) Press “Up and down ”and “Left and right ”to manually adjust the position of the optical fiber on the x screen.

(6) Press “X/Y” to switch to the Y screen

(7) Press “Up and down ” and “Left and right ”to manually adjust the position of the optical fiber on the Y screen.

(8) Done